CalAmp ITC 220 User manual - page 59
ITC 220 Base Station, Locomotive & Wayside Radio Transceiver Field Service Guide PN 0046300120 Rev. A
| Page 53
6. Under File Type, select App.
7. Click Browse, then locate and select the software image file.
8. After you select the software image file:
The Destination File Name field is automatically populated with a file name derived from the selected image file
name.
Ensure that the destination file name meets the 8.3 filename requirements, meaning that the filename can have
at most eight alphanumeric characters, followed by a period and extension of at most three alphanumeric
characters. A few special characters are also allowed (namely, ! # $ % & ' ( ) - @ ^ _ ` { } and ~) Alphabetical
characters are treated as case-insensitive.
9. To select this image immediately after it is downloaded, select the Select check box.
When you select the Select check box, XtermW automatically executes the APPS,SELECT,image-file
command after the software image is downloaded. It also causes XtermW to enable the Boot check box.
The Boot check box is available only when you select the Select check box. When you select the Boot check box,
XtermW automatically executes the BOOT command after the APPS,SELECT,image-file command, causing
the newly downloaded image to become the active image after a reboot.