Caliber RMD602 Operating instructions manual - Rotary Knob Menu
7
Rotary Knob Menu
1. Rotate the knob to adjust volume level.
2. Short press to access the Audio & Video
Setting menu.
Each press the knob to change the AUDIO
mode: EQ/Bass/Treble/Balance/Fader, and
rotate the knob to adjust level.
Each press the knob to change the VIDEO
mode: Bright/Contrast/Saturation, and rotate
the knob to adjust level.
EQ: USER/FLAT/POP/ROCK/CLASSIC/
JAZZ
The Equalizer function applies preset sound
effects to the unit’s audio output signal. Turn
the rotary encoder to select from the following
equalizer options: USER, FLAT, POPULAR,
ROCK, CLASSIC, JAZZ. With the equalizer
function activated, if bass or treble is adjusted,
the EQ Mode will revert to “USER”. When
the equalizer function is activated, the most
recently selected bass/treble levels cannot be
adjusted. When the equalizer function is not
active, the unit will return to the most recently
selected bass and treble levels.
3. Press the knob more than 2 seconds to
enter Setting mode, then Use
, /
and OK key to select setting items.
General Setting
BEEP: ON/ OFF
The beep tone feature allows the selection of
an audible beep tone to be heard each time
the menu is accessed.
LOUDNESS: ON/OFF
When listening to music at low volumes, this
feature will selectively boost certain bass and
treble frequencies.
TIME MODE
12 HOUR MODE: the clock displays in the
type of 12 hours such as 11:18 AM.
24 HOUR MODE: the clock displays in the
type of 24 hours such as 20:18.
TIME ADJUST
Press / or / key to set hour and minute.
Each time you press / to select one
segment of the clock display:
Hour-Minute
As you select segments of the clock display
the segment selected will be highlighted. Then
you can press / to put a clock right.
PARKING: ON/OFF (optional)
When it is in Parking “On” mode, if you play
the video file, the screen will show “WARNING:
Engage Parking Brake to View Video”.
MIRROR: ON/OFF
This option allows for selection of a mirror
image view when a rear view backup camera
(sold separately) is connected to the CAMERA
IN input on the back of the radio. Turn the
rotary encoder to select “On” or “Off”.
.
.
.