Calix T073G HGU ONT User Manual - page 15
Installation
• Verify that the
AUTH LED light is green, indicating that the ONT is operating
normally.
The ONT is placed into service remotely through the OLT. Services to the ONT
are likewise provisioned and turned up remotely through the PON network.
• If the
AUTH LED is blinking, indicating that the ONT is communicating with
the PON network, no further activation is necessary and you can proceed
to Section 3.6.2 Verifying Services on page 11 for verifying services.
• If the
AUTH LED does not light green, contact the Network Operation
Center (NOC) to activate the line. You may be required to provide or
confirm the following information about the ONT: vendor, model number,
serial number. Once the ONT has been activated in the network, and the
AUTH LED is lit green, you can proceed to Section 3.6.2 Verifying Services
on page 11 for verifying services.
3.6.2
Verifying Services
Follow local practices to connect to each active service port in the ONT to
confirm service activation.
• Connect to each active phone jack to verify telephone numbers and
services. Verify that the
TEL1 or TEL2 LED lights flashing green when a
line is off-hook.
• If Ethernet service is included in this installation, confirm that data is being
received and transmitted normally. The
LAN1 or LAN2 or LAN3 or LAN4
LED will be flashed during data transmission.
• If WLAN service is included in this installation, confirm that data is being
received and transmitted on WLAN interface. Verify the
WLAN LED is
green when the WLAN is connected.
220-00602 R10 | October, 2013
11