CALOR DG3000WHB-7B Installation And Operation Instructions Manual - page 4
Manual is about: WATER RADIANT HEATING TOUCH SCREEN THERMOSTAT
of
12
4
positive (+) ends of batteries with positive
(+) battery terminals in the battery
compartment.
3. Connect wires beneath terminal screws on power
supply module using appropriate wiring
schematic. See figure 4
4. Push power base into wall.
5. Using two mounting screws mount the power
base to the wall. Place a level against bottom of
base, adjust until level, and then tighten screws.
(Leveling is for appearance only and will not
affect thermostat operation.)
6. Replace control panel on the power base and fix
power base and control panel by removed two
screws in item 1