CAMBOARD MMX 32 VGA MTP User Manual

Manual is about: Mini Matrix Switcher

Summary of MMX 32 VGA MTP

  • Page 1

    User’s manual © 2005 extron electronics. All rights reserved. Extron electronics, usa 1230 south lewis street anaheim, ca 92805 usa 714.491.1500 fax 714.491.1517 extron electronics, europe beeldschermweg 6c 3821 ah amersfoort the netherlands +31.33.453.4040 fax +31.33.453.4050 extron electronics, as...

  • Page 2

    Fcc class a notice note: this equipment has been tested and found to comply with the limits for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial envir...

  • Page 3

    I mmx 32 vga mtp • table of contents chapter 1 • introduction .......................................................... 1-1 about this manual ................................................................ 1-2 about the mmx 32 vga mtp .......................................... 1-2 features ..........

  • Page 4: Chapter One

    Ii mmx 32 vga mtp • table of contents table of contents, cont’d mmx 32 vga mtp 1 chapter one introduction about this manual about the mmx 32 vga mtp features all trademarks mentioned in this manual are the properties of their respective owners. 68-789-20 rev. A 08 05 contact closure control ...........

  • Page 5

    Mmx 32 vga mtp • introduction mmx 32 vga mtp • introduction introduction features inputs — the mmx vga mtp has three female 15-pin hd input connectors, each with a 3.5 mm stereo jack. Outputs — the unit routes computer video and audio signals to two outputs: • output 1 is a local output, using one f...

  • Page 6: Chapter Two

    Mmx 32 vga mtp • introduction introduction mmx 32 vga mtp 2 chapter two installation and operation mounting the mmx 32 vga mtp rear panel features and cabling front panel features and operation 1-4 im vertrieb von camboard electronics www.Camboard.De tel. 07131 911201 fax 07131 911203 ce-info@camboa...

  • Page 7

    Mmx 32 vga mtp • installation and operation mmx 32 vga mtp • installation and operation installation and operation 2-3 6" deep rack shelf front false faceplate uses 2 screws. 1/2 rack width front false faceplate use 2 mounting holes on opposite corners. (2) 4-40 x 3/16" screws figure 2-1 — mounting ...

  • Page 8

    Mmx 32 vga mtp • installation and operation mmx 32 vga mtp • installation and operation installation and operation, cont’d 2-5 rear panel features and cabling input 2 input 1 audio audio output 1 l r audio input 3 audio audio power 12v 0.5a max remote rs-232 +5v 2 1 1 2 3 tx rx sync - tri pre peak -...

  • Page 9

    Mmx 32 vga mtp • installation and operation mmx 32 vga mtp • installation and operation installation and operation, cont’d 2-7 remote control connections 7 contact closure connectors — these two 5-pole captive screw connectors provide remote contact closure control of outputs 1 and 2 by connecting e...

  • Page 10

    Mmx 32 vga mtp • installation and operation mmx 32 vga mtp • installation and operation installation and operation, cont’d 2-8 power connection 9 power connector — an external 12 v dcpower supply is included with the unit. Plug it into this 2-pole 3.5 mm captive screw connector. Wire the connector a...

  • Page 11

    Mmx 32 vga mtp • installation and operation mmx 32 vga mtp • installation and operation installation and operation, cont’d 2-11 front panel features and operation mmx 32 vga mtp output 1 2 1 3 output 2 2 1 3 1 2 figure 2-9 — front panel features 1 input selector buttons and leds for output 1 — press...

  • Page 12: Chapter Three

    Mmx 32 vga mtp • installation and operation installation and operation, cont’d mmx 32 vga mtp 3 chapter three remote control output control rs-232 control contact closure control 2-12 im vertrieb von camboard electronics www.Camboard.De tel. 07131 911201 fax 07131 911203 ce-info@camboard.De.

  • Page 13

    Mmx 32 vga mtp • remote control remote control mmx 32 vga mtp • remote control simple instruction set control host-to-switcher instructions the switcher accepts sis commands through the remote connector. Sis commands consist of one or more characters per command field. They do not require any specia...

  • Page 14

    Mmx 32 vga mtp • remote control remote control, cont’d mmx 32 vga mtp • remote control 3-5 using the command/response table the sis command/response table begins on the next page. Lower case letters are acceptable in the command field only where indicated(b/b, for example). Symbols are used througho...

  • Page 15

    Mmx 32 vga mtp • remote control remote control, cont’d mmx 32 vga mtp • remote control 1 output 1’s video and audio are both supplied by input 1. 2 output 2’s video and audio are both supplied by input 2. 3 output 1 does not mute video or audio. 4 output 2 does not mute video or audio. Loading firmw...

  • Page 16

    Mmx 32 vga mtp • remote control remote control, cont’d mmx 32 vga mtp • remote control 3-9 figure 3-3 — select the firmware upgrade file figure 3-4 — upload progress display 8 . After several minutes, the switcher reports the start-up copyright message: (c) copyright 2005, extron electronics “mmx 32...

  • Page 17

    Mmx 32 vga mtp • remote control remote control, cont’d mmx 32 vga mtp • remote control figure 3-5 — universal switcher control program window resetting the switcher the unit reset window allows you to clear all user settings and reset the switcher to its factory settings. To reset the switcher: 1. C...

  • Page 18

    Mmx 32 vga mtp • remote control remote control, cont’d mmx 32 vga mtp • remote control using the help system for information about program features, you can access the help program in any of the following ways: • from the extron program group, double-click the universal switcher help icon. • from wi...

  • Page 19

    Mmx 32 vga mtp • remote control remote control, cont’d mmx 32 vga mtp • remote control contact closure connectors 4 5 vdc pole — connect this pole of the captive screw connector to the 5 v dc pole on either output 1 or output 2’s remote captive screw connector on the mmx 32 vga mtp’s. 5 gnd pole — c...

  • Page 20: Appendix A

    Remote control, cont’d mmx 32 vga mtp • remote control mmx 32 vga mtp a appendix a specifications, part numbers, and accessories specifications included parts optional accessories 3-16 im vertrieb von camboard electronics www.Camboard.De tel. 07131 911201 fax 07131 911203 ce-info@camboard.De.

  • Page 21

    Mmx 32 vga mtp • specifications, parts, and accessories mmx 32 vga mtp • specifications, parts, and accessories specifications, parts, and accessories a-3 nominal level .............................. 1 vp-p for y of component video and s-video, and for composite video 0.7 vp-p for rgb and r-y and b-...

  • Page 22

    Mmx 32 vga mtp • specifications, parts, and accessories mmx 32 vga mtp • specifications, parts, and accessories specifications, parts, and accessories, cont’d general external power supply ............... 100 vac to 240 vac, 50/60 hz, external, autoswitchable; to 12 vdc, 1 a, regulated power input r...

  • Page 23

    Mmx 32 vga mtp • specifications, parts, and accessories specifications, parts, and accessories, cont’d a-6 included parts these items are included in each order of mmx 32 vga mtp: replacement part number mmx 32 vga mtp 60-769-01 12 vdc, 1.0 a external power supply 28-071-01 3.5 mm, 5-pole captive sc...