CAMBOARD MMX 32 VGA MTP User Manual - page 7
MMX 32 VGA MTP • Installation and Operation
MMX 32 VGA MTP • Installation and Operation
Installation and Operation
2-3
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes
on opposite corners.
(2) 4-40 x 3/16"
Screws
Figure 2-1 — Mounting the MMX 32 VGA MTP on a
6" rack shelf
Use 2 mounting holes
on opposite corners.
(2) 4-40 x 3/16"
Screws
NOTE:
Using screws longer
than 3/16” will damage the
unit and void the warranty.
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Figure 2-2 — Mounting the MMX 32 VGA MTP on a
standard rack shelf
Mounting the MMX 32 VGA MTP
The MMX 32 VGA MTP can be set on a table, mounted on a rack
shelf, or mounted under a desk, podium, or tabletop.
Tabletop use
Four self-adhesive rubber feet are included with the switcher.
For tabletop use, attach one foot at each corner of the bottom of
the unit, and place the unit in the desired location.
Rack mounting
For optional rack mounting, mount the switcher on any of the
following rack shelves:
•
6" deep 1U rack shelf kit (part #60-190-10)
•
6" deep basic 1U rack shelf (part #60-604-10)
•
Standard universal 1U rack shelf kit (part #60-190-01)
(figure 2-2)
•
Basic universal 1U rack shelf (part #60-604-01)
On the standard rack shelf, the switcher mounts in one of four
locations to the rear of the rack or in one of four locations to the
front of the rack.
1
.
Remove rubber feet if they were previously installed on
the bottom of the switcher.
2
.
Mount the switcher on the rack shelf, using two
4-40 x 3/16" screws in opposite (diagonal) corners to
secure it to the shelf.
3.
Install blank panel(s) or other unit(s) on the rack shelf.
4.
Attach the rack shelf to the rack using the supplied bolts.
2-2
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de