CAME ZA3N Installation Manual - page 6
4
1
$ $9 # #
6
7
8 9
:
& &
4
1
$ $9
p.
66
- M
anu
al
31
9
U
4
6
EN
31
9
U
4
6
EN
v.
33
- 0
7/
20
15 - © C
ame S
.p
.A
. - T
he manu
al
's
c
onte
nts ma
y b
e e
dite
d at an
y time with
ou
t n
oti
ce
.
Signalling and lighting devices
Open gate light-indicator(Socket rating: 24V - 3W max.). Turns on
when the gate is open. It turns off when the gate is closed.
Flashing light (Socket rating: 230V A.C. - 25W max.)
- Flashes during opening and closing phases.
Cycle lamp connection
(230V-60W)
This lamp lights up the vehicle manouvering
area and stays on from the moment the gate
leaves start opening until total stop takes
place (including automatic closing time). If
the automatic closure is not inserted it stays
lit up only while it is moving.
Control devices
Stop button ( N.C. contact)
- Gate stop buttom excluding automatic closing cycle; to start up movement
again press the command button or the transmitter button. (Bridge if unused)
Keyswitch and/or open button (N.O. contact)
- Gate opening command.
Keyswitch and/or comand button (N.O. contact)
- Gate opening/closing command. By pressing the button or
turning the selector key, the gate inverts is movement or stops
depending on the choice you have made on the Dip-switch (see
selecting functions, Dips 2 and 3).
Keyswitch and/or partial open button (N.O. contact)
- One gate leaf opening command to allow pedestrian passage (M2
opens).
Keyswitch and/or close button (N.O. contact)
- Gate closing command.