CAME ZA3N Installation Manual - page 8
ON
OFF
/.
- -
6
7
8 9
:
& &
4
1
$ $9 # #
-5
$5
-5
- -
6
7
8 9
:
& &
4
1
$ $9 # #
-5
$5
-5
4#!
42-
4,
p.
88
- M
anu
al
31
9
U
4
6
EN
31
9
U
4
6
EN
v.
33
- 0
7/
20
15 - © C
ame S
.p
.A
. - T
he manu
al
's
c
onte
nts ma
y b
e e
dite
d at an
y time with
ou
t n
oti
ce
.
7 Selecting functions
DIP-SWITCH 10 WAYS
8 Adjustments
1 ON
Automatic closing activated (1 OFF-disactivated);
2 ON
“Open-stop-close-stop” function with button (2-7) and radio control (with built-in AF card) - activated;
2 OFF
“Open-close” function with button (2-7) and transmitter (with built-in AF card) - activated;
3 ON
“Open only” function with transmitter (built-in AF card) - activated (3 OFF-disactivated);
4 ON
Pre-Flashing during opening and closing – activated (4 OFF- disactivated);
5 ON
Obstacle detection - activated (5 OFF- disactivated);
6OFF
“Maintained action” (the transmitter cannot work) deactivated (6 ON - activated);
7 ON
Ram blow activated; at each opening command, the gate leaves press when against the closing jamb for a second,
helping to release the electro-lock connected up on terminals 11-S. It is active only if the leaves are closed and
when operating time is over, or upon the 1st run after powering up the system;
8 OFF - 10 OFF
Re-close during opening function (connect the safety device on 2-CX) - activated;
8 OFF - 10 ON
Partial stop function (connect the safety device on 2-CX) - activated (if the devices on 2-CX are not used, set the
DIP 8 in ON);
9 OFF
Re-open during closing function - activated; connect the safety device on 2-C1 (if the device on 2-CX is not used,
et the DIP in ON).
Trimmer T.L. = Adjusting the working time from 10” to 120”.
Trimmer T.C.A. = Adjusting the automatic closing from 1” to 120”.
Trimmer TR2M = Adjusting the M2 closing delay (min. 0”, max. 15”) and simultaneous partial opening (min. 0”, max. 30”).