Caminetti Montegrappa LIGHT 06 Installation, Use And Maintenance Manual - page 28
LIGHT series
ENGLISH
3.1 Pre- and
fi
rst-lighting
instructions
Before lighting the appliance for the
fi
rst time the following
must be provided:
remove the sticker from the glass and any adhesive marks if
t
necessary;
t
ensure that all safety requirements are met (see sections 1.5
and 1.6);
"55&/5*0/ 5P BWPJE ZJFMEJOH BOE CSFBLBHFT PS
GFBTJCMFCVSTUJOHPSFYQMPTJPOJOFYDFQUJPOBMDBTFTPG
UIF$.UFDIQBSUTZPVBSFSFDPNNFOEFEUPTUSJDUMZ
GPMMPXUIFJOEJDBUJPOTHJWFOGPSöSTUUJNFTUBSUJOH
To start the
fi
re for the
fi
rst time, follow the technical instructions
given at the beginning of section 3.2. Take particular care to
keep the
fi
re moderate for about 15/20 minutes, then let the
fi
re go out and, to make sure all the humidity dries out, repeat
the procedure 3/4 times, each time waiting for the refractory
elements to cool down.
After this time, a more lively
fi
re can be built by gradually
adding fuel until reaching the maximum amount suggested
(see “hourly fuel consumption” in the chart under section 1.3)
and once the
fi
re is established, keep it for about 2 hours,
maintaining the air damper open.
$"65*0/$IJMESFONVTUCFTVQFSWJTFECZBOBEVMUJO
PSEFS UP QSFWFOU UIFN GSPN UPVDIJOH UIF BQQMJBODF
IPUQBSUTPSNPEJGZJOHJUTGVODUJPOT
5IF NFUBM DPNQPOFOU QBSUT PG UIF BQQMJBODF BSF
DPBUFEXJUIBTQFDJBMIJHIUFNQFSBUVSFQBJOUUIBUXJMM
SFUJDVMBUFDIFNJDBMMZTUBCJMJ[FBOECFDPNFGVMMZIFBU
SFTJTUBOU BGUFS UIF öSTU GFX MJHIUJOHT %VSJOH UIJT
DIFNJDBMSFBDUJPOUIFQBJOUXJMMTNFMMCBEBOESFMFBTF
WBQPVST UIVT JU JT SFDPNNFOEFE UIBU UIF SPPN CF
QSPQFSMZBFSBUFE"GUFSUIFBCPWFQSPDFTTJTPWFSOP
NPSFCBETNFMMBOEWBQPVSTXJMMCFSFMFBTFEEVSJOH
UIFBQQMJBODFOPSNBMPQFSBUJPO
3.2 Following lightings
Before lighting the
fi
re always clean the ceramic glass door if
necessary (see section 4.1.2) and the
fi
rebox and empty the
ash tray (see section 4.1.3).
On lighting the
fi
re set the controls as follows:
t
combustion air damper fully open: using the adjustment
handle, turn to the right to open and to the left to close (see
fi
gures 1 and 2);
t
warm air outlets with adjustable louvers open;
OPERATION
3.
3
"55&/5*0/ 5P BWPJE ZJFMEJOH BOE CSFBLBHFT PS
GFBTJCMFCVSTUJOHPSFYQMPTJPOJOFYDFQUJPOBMDBTFTPG
UIF$.UFDIQBSUTGPMMPXJOHBQFSJPEPGJOBDUJWJUZJU
JTBHPPESVMFUPUBLFUIFPWFOTUPWFHSBEVBMMZUPUIF
XPSLJOHUFNQFSBUVSFXJUIBNPEFSBUFöSFSFQFBUJOH
UIFTUFQTPOTFDUJPO
It may seem easy to light a
fi
re in a wood-burning appliance
but it actually is not. You should not play with
fi
re, you should
take great precaution and follow the instructions given in this
chapter very carefully.
To start the
fi
re safely use the traditional “
fi
relighter cubes”
instead of grease-proof or printed paper, or other products
available on the market speci
fi
cally designed to make the
lighting of the
fi
re easy, and follow the instructions supplied.
Such products contain special substances helping the wood
pieces to catch
fi
re by feeding the
fl
ames for a longer time.
After positioning a
fi
relighter cube on the ash-riddling grate,
prepare a bed with small, thin pieces of dry wood (the smaller
and dryer they are the better they will catch
fi
re). Cross the
wood pieces in a stack, so as to let air pass in between: if the
wood is too much piled, it does not burn properly.
When the
fi
re is well established and a bed of embers has
formed (after about 15 min.), put additional wood pieces
of bigger dimensions, again in crossed position, but do
not exceed the optimum amount of fuel (see “hourly fuel
consumption” in the chart under section 1.3).
$IFDLUIBUUIFDIJNOFZESBXTXFMM.BOZDIJNOFZTJO
DBTFPGMPXQSFTTVSFPSXIFOUIFZBSFDPMENBZQSFTFOU
ESBVHIU QSPCMFNT *G ESBVHIU JT HPPE ZPV DBO MJHIU
UIFöSFGSPNUIFCPUUPNPGUIFXPPETUBDLJGESBVHIU
JTQPPSUIFTUBDLNVTUCFCVJMUXJUIIJHIMZDPNCVTUJCMF
WFSZ UIJO QJFDFT PG TPGU XPPE QSPWJEJOH B MJWFMZ öSF
XIJDI TIPVME IFBU VQ UIF DIJNOFZ øVF SBQJEMZ BOE
QSFWBJMPWFSESBVHIUQSPCMFNT
Wait for the
fi
re to set-in properly (about one hour) then
adjust the air
fl
ow by adjusting the combustion air control
(see
fi
gures 1 and 2); it is very important that both the
appliance and the chimney
fl
ue be su
ffi
ciently warm to keep
a good draught and reach the critical temperature ensuring
the proper combustion of wood.
When the
fi
re is well established, which is apparent when
the CMtech™ lining becomes lightcoloured, the
fi
rebox may
be reloaded in accordance with the already recommended
optimum amounts of fuel (wood logs not longer than 33
cm with 30/35 cm girth). With the amount of fuel indicated
above, approximately, the appliance will achieve the heat
e
ffi
ciency declared with an ideal ratio of fuel consumption to
heat output.
5IF VTF PG XPPE BNPVOUT NVDI MBSHFS UIBO UIPTF
JOEJDBUFE XJMM OPU POMZ IBWF B IBSNGVM FòFDU PO UIF
DPOTVNQUJPOUPPVUQVU SBUJP CVU NBZ FWFOUVBMMZ
SFEVDFUIFEVSBCJMJUZPGUIFTUSVDUVSF8IFOMPBEJOH
UIF öSFCPY HFOUMZ TFU UIF öSFXPPE QJFDFT EPXO PO
UIFIFBSUI /PUF5IFXPPEJTTJNQMZUPCFMBJEJOUIF