Campersat Satellite system Supplementary installation handbook - page 3
Campersat AutoSeek Autoskew
3
H4441 Build 4441 August 2008
Shipped items
When unpacking you should find the following:
Plastic bag with:
- 5m Cable from TopBox to Receiver
- 3 – pin power supply strip (RED: +12V, BROWN: GND, Black: Ignition)
- TV coaxial cable
- SCART cable
- SCART adaptor
- Operating instructions
- Fitting instructions (this document)
- 6 screws for the mounting plate
- 4 bolts to fit the dish to its bracket
- 4 screws to fit the aluminium elbow (cable-feed-through)
- 2 or 3 way AV Switch Unit
- LNB Switch Unit
Fitting
1. Preparations
Check whether the roof of the vehicle (onto which the fitting is intended) is strong and
stable enough. If not, or unsure, obtain a sheet of aluminium, approximately 2mm thick
1m x 1m size and fit this to the roof first. If in doubt contact the
manufacturer of the vehicle to obtain information about its permissible roof load.
To fit the system you will need a spanner, size 13mm, a+“(Phillips) screwdriver, a drill
with 15mm diameter, a sharp blade and possibly some cleaning fluid. You must obtain a
strong adhesive glue like “sicaflex” or similar.Bathroom silicone is NOT sufficient.
2. Find the fitting location
When you are sure about the permissible load to the roof you will need to find a suitable
location for the system. Refer to page 5 for the space needed. Tentatively put the
mounting plate onto the desired space. Spend a minute to think about
twiring,(downwards to the receiver) that will be needed later on. It is much easier to
install the wiring on top of the roof than inside the vehicle.