Campersat Satellite system Supplementary installation handbook - page 9
Campersat AutoSeek Autoskew
9
H4441 Build 4441 August 2008
8.Safety / Ignition OFF
The 3-pin power connector holds a third line, colored black. This is to automatically
retract the antenna if the vehicles motor is started.
The automatic retraction will avoid any damage to the system if the owner
accidentally forgets to switch the system off properly before starting to travel.
You must connect the ignition line to the vehicle’s ignition control line to get this
feature working. No special cable diameter is required, as this line is control only, not
a power line. The control voltage must be > 8V and < 30V.
9. Interconnection
10. Fitting of dish
When all interconnection and fitting is done you have to fit the dish finally.
Attention: Before the first power up, check if all tools have been removed from the
TopBox. It might be a good idea to have an assistant watching the TopBox when it is
coming up first, if you do not have direct sight to it when first powering up.
a) Switch on the main power switch on the receiver to “ON” (I).
b) Watch the sat-mouse. If you see a moving bar the antenna will go up. If you just
see a small dot, press the red button on the remote to get it up. If you see two bars
for more than 5 seconds then something may be wrong with the power supply.
c) Watch the antenna while it is going up. As soon as the arm is roughly vertical or
slightly over vertical press EXIT on the remote. The antenna has to stop movement
immediately.
Be sure to beam the remote towards the sat-mouse while pressing EXIT and to mount
the batteries into the remote before this operation. When the arm is approximately
vertical and stopped, you can fit the dish onto the arm.