CamRanger CamRanger User Manual - page 13
© CamRanger – Patent Pending
13
Timer
The timer tab allows the use of the CamRanger as an intervalometer as well as
specifying exposure times when the camera is in bulb mode.
Time Lapse
• The entry fields are used to specify the initial delay before the first shot,
the number of shots to take, and the delay in between each shot.
• After configuring the settings, press the “Start” button to begin the
intervalometer process.
• The intervalometer commands are stored on the CamRanger device and
the Android device does not need to remain on or connected.
• The “Shot Delay” should not be used for precision timing, particularly
when the delay is only a few seconds or less.
• Once an intervalometer sequence is begun, it can only be cancelled by
turning off power to the CamRanger device.
• Time Lapse – Bulb
o If the camera is in bulb mode/shutter speed and the camera
supports bulb shots, CamRanger will take Bulb shots during the
time lapse. The bulb duration is specified by the Shot Duration,
located within the Bulb section immediately below the Time Lapse
section.
• Before starting the time lapse sequence, a dialog will appear informing
the user of the time lapse parameters and provide an opportunity to
cancel.
Bulb
• The Bulb controls are only enabled when the camera is in bulb mode and
the camera supports remote bulb shots. Note: For some cameras, bulb
mode is set by changing the shutter speed to “bulb.”
• The entry fields are used to specify the initial delay before the first shot
and the length of the exposure.
• After configuration, press the “Start” button to begin the bulb process.
• The bulb commands are stored on the CamRanger device and the Android
device does not need to remain on or connected.