CamRanger CamRanger User Manual - page 6
© CamRanger – Patent Pending
6
By selecting the appropriate network pressing the “Connect” button, the Android
device will connect to the CamRanger network. Note: It is not necessary to go into
the Android device’s Internet settings to switch to the CamRanger network after
registration. However, as a troubleshooting method, setting the WiFi network
within the Android settings can be done.
Within the Settings on the Android device connect to your CamRanger network. The
SSID will be CamRanger-‐###, with the last three characters matching the last 3
characters of the CamRanger’s serial number. The password is the full 8 characters
of the CamRanger’s serial number. The password MUST BE ENTERED IN ALL CAPS.
The keyboard on newer Android devices can be put into caps lock by double tapping
the shift key.
Connect the CamRanger to the camera using the provided black USB cable. The male
A end is inserted into the USB port at the end of the CamRanger, and the other end is
connected to the USB port of the camera. Then ensure the camera is turned on.
When the camera is connected and turned on the green light closest to the edge of
the CamRanger device will light.
Launch the CamRanger Android app. The application will connect to the CamRanger
and the user will be able to control the camera. Ensure that your camera and
CamRanger battery are charged when starting your CamRanger session. For
common problems with setup and connection refer to the Troubleshooting section
at the end of the manual.