Can-Am DS250 Operator's Manual - Drive Chain And Sprockets
MAINTENANCE PROCEDURES
Beam Aiming Adjustment
To adjust the headlight beam, proceed
as follows.
Loosen the screws shown in the fol-
lowing illustration, but do not remove
them.
vmo2009-002-002_a
1. Screws to be loosened
Adjust headlight housing angle by
hand.
Adjust both headlights evenly.
Tighten bolts when proper adjustment
is obtained.
Taillight Bulb Replacement
Ensure the ignition switch is in the OFF
position.
Unscrew lens screws and remove lens
to expose bulb.
V06G0UY
1
2
1. Lens
2. Screws
Push bulb in and hold as you turn it
counterclockwise to release it from
the socket.
Install the new bulb by first pushing
and holding it in as you turn it clock-
wise to lock it in the socket.
Check light operation after bulb re-
placement.
Reinstall lens.
Drive Chain and Sprockets
NOTICE
Check
drive
chain
for
proper adjustment and lubrication
before each use.
CAUTION Ensure the engine
is OFF and parking brake is engaged
before checking, adjusting or lubri-
cating the drive chain.
NOTICE
Never operate this vehi-
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
102
______________