Can-Am DS250 Operator's Manual - 8) Ignition Switch
CONTROLS/INSTRUMENTS/EQUIPMENT
vmr2006-083-011_b
1. Reverse lamp (RED)
2. Neutral lamp (GREEN)
3. Engine temperature (RED)
Engine Temperature (RED)
This light comes on when the
ignition switch is turned ON and
remains on for approximately 1
second.
When this indicator light is
ON during engine operation,
it
indicates
the
engine
is
overheating.
If
engine
overheats,
refer
to
ENGINE OVERHEATS
in
TROUBLESHOOTING
.
NOTICE
If the light does not turn
off right after engine starting, stop
engine. See an authorized Can-Am
dealer. Do not use the vehicle until
repaired.
Reverse Lamp (RED)
When
lit,
it
indicates
the
transmission
is
in
reverse
position.
Neutral Lamp (GREEN)
When
lit,
it
indicates
the
transmission
is
in
neutral
position.
8) Ignition Switch
The ignition switch is located in the
middle of the handlebar.
It is a key-operated, 2 position switch;
OFF and ON (with lights).
vmr2006-083-011_c
TYPICAL — IGNITION SWITCH POSITIONS
1. Ignition switch
2. OFF
3. ON with lights
Insert key in switch and turn to ON po-
sition. To remove key, turn key to OFF
position then pull it out.
Remember that having the lights on
without the engine running discharges
the battery. Always turn ignition to
OFF position after engine has been
stopped.
NOTE: While
the
engine
can
be
stopped by turning the ignition key
to OFF position, we recommend the
engine be stopped by using the emer-
gency engine stop switch.
9) Fuel Valve
The fuel valve is located on the RH side
of the vehicle near the engine.
This is a 3 position rotary valve; OFF,
ON, RES (reserve). Rotate the valve to
align its pointer to the desired position.
_______________
67