Canford MINX MIXER Operating Instructions Manual - page 8
02-406 (Issue 1) 01/03
MINX MIXER - OPERATING INSTRUCTIONS
- 8 -
Phantom Power (obsolete version using 22.5 volt camera batteries)
Derived from 2 x B122 22.5 Volt batteries only, they are housed in the battery compartment.
Consumption is approximately 2 - 3mA per microphone being powered. Approximate battery life
is 8 hours.
NOTE: The Minx has no provision for recharging the Phantom power batteries, once expired they
must be replaced. Batteries must be fitted if phantom power is required when using the Minx on
AC.
If the Minx is not being used ensure that Phantom power mics are either unplugged from the
mixer or the Mic/Line switch is set to LINE.
When using Dynamic mics ensure that both B122 batteries are removed from the battery
compartment.
B122 batteries are no longer available.
Addition of the Phantom Power Module to existing Minx Mixers is a chargeable factory retrofit.
12 Volt Powering – Optional – Models AT and BT
Derived from PP3 batteries or AC supply, connected to microphone when locking toggle switches
are selected in DOWN position.
NOTE:
If Mic/Line switch is in line position ensure that corresponding ‘T’ Power toggle switch is in the
‘OFF’ (up) position. When using Dynamic microphones ensure that corresponding ‘T’ power
toggle switch is in the ‘OFF’ position otherwise damage to the microphone may result.
WARNING:
Do not use 12 Volt ‘T’ Powering with 48 Volt Phantom power microphones or Dynamic mics.
Do not use 48 Volt Phantom powering with 12 Volt ‘T’ Power microphones or Dynamic
microphones.
CANFORD AUDIO PLC
CROWTHER ROAD WASHINGTON
TYNE & WEAR NE38 OBW, UK
admin (0191)418 1000
sales (0191)418 1122
fax (0191)418 1001
technical data