Canford MINX MIXER Operating Instructions Manual - page 9
02-406 (Issue 1) 01/03
MINX MIXER - OPERATING INSTRUCTIONS
- 9 -
TECHNICAL SPECIFICATION
Input
Noise Referred to Input
Measurement Method
Mic
Line
Output Noise
22Hz to 22KHz RMS -121.1dB
-79.7dB
-75.0dB
A weighted RMS
-124.7dB
-82.3dB
-78.1dB
CCIR weighted RMS -117.9dB
-73.4dB
-69.0dB
CCIR weighted quasi peak
-112.1dB
-69.3dB
-65.1dB
CCIR/ARM ref 2kHz -122.8dB
-80.0dB
-75.7dB
Harmonic Distortion
Impedance
Mic > 1K ohm floating
(Both transfer bal.)
Line > 10K ohm bridging
Sensitivity
-70dBm to - 40dBm (Mic)
(Fader fully open)
-20dBm to + 10dBm (Line)
Headroom at Inputs Mic better than 30dB
(Fader fully open)
Line better than 20dB
Amplitude-frequency response
(w.r.t. 1KHz)
40Hz – 15KHz
±
1.0dB
125Hz – 10KHz
±
0.5dB
Hi-pass filter
-3dB at 80Hz
Slope = 6dB/octave
Wiring Conventions
XLR - Type connectors:
Pin 1
= Ground
Pin 2 =
+ve Phase or ‘Hot’
Pin 3 =
-ve Phase or ‘Cold’
RCA Phono connectors:
Tip
= +ve Phase or ‘Hot’
Ring
= -ve Phase or ‘Cold’
1/4” Jacks connectors
Tip
= +ve Phase or ‘Hot’
Ring
= -ve Phase or ‘Cold’
Sleeve
= Ground
Bare wire terminals:
Red
= +ve Phase or ‘Hot’
Black
= -ve Phase or ‘Cold’
CANFORD AUDIO PLC
CROWTHER ROAD WASHINGTON
TYNE & WEAR NE38 OBW, UK
admin (0191)418 1000
sales (0191)418 1122
fax (0191)418 1001
technical data