Cannon CANTERBURY Instruction Manual - page 10
10 | Cannon Canterbury Freestanding
FRONT GLASS REMOVAL AND INSTALLATION
Front Glass Installation
1. P
lace heater in position. (Check flue and gas
connection positions. Refer to gas connection
instructions on page 12 and flue installation
instructions on pages 11)
2. Remove the front glass surround by holding it firmly
on either side and pulling it towards yourself.
refer FIG 6.
3. Remove the inner glass. Slacken off screws in
top clamp and remove side clamps.
Refer to FIG 7.
To Refit The Front Glass Surround
Ensure that the glass surround is replaced the correct
side up. The rearward sloping frame must be at the top
and the vertical edge must be at the bottom.
Refer FIG 8.
This heater can be placed on either combustible or non
combustible floor surfaces.
FIG 6
FIG 7
Top: rearward sloping frame
FIG 8
Bottom: vertical edge