Cannon CANTERBURY Instruction Manual - page 13
Cannon Canterbury Freestanding | 13
LOG INSTALLATION
1. The burner is contained within the burner chamber.
Refer FIG 12.
2. Carefully unpack the log set. Logs are numbered
as follows:
#1 - Left front log
#2 - Left back log
#3 - Right front log
#4 - Right back log
Position the four individually numbered logs in the
following order on the burner bed as shown in
FIG 13-16. The locating pins on burner bed must engage
with corresponding holes in the individual logs.
a) Place log #1 into the 2 front left pins on the burner bed,
ensuring that the charring faces the front.
Refer FIG 13.
b) Place log #2 onto the 2 left back pins. Refer FIG 14.
c) Place log #3 on single right front pin, ensure fork
locates over log #2. Refer FIG 15.
d) Place log #4 on single right back pin, ensure left side
of log rests on depression in #3 log. Refer FIG 16.
3. Refit t he inner glass, making sure not to over
tighten the screws.
4. Refit the front glass surround.
FIG 13
FIG 14
FIG 16
FIG 15
Burner in base of
chamber
burner
FIG 12