Cannon CANTERBURY Instruction Manual - page 9
Cannon Canterbury Freestanding | 9
CANTERBURY FREESTANDING INSTALLATION INSTRUCTIONS
Overview
1. T
his appliance MUST be installed by an authorised
service person only.
2. T
his appliance shall be installed in accordance with
these manufacturer’s installation instructions, local
gas fitting regulations, municipal building codes,
electrical wiring regulations, and AS/NZS 5601.1 the
Australian Standard for Gas Installations.
Refer also AS/NZS 5601.1 for gas pipe sizing tables.
NOTE: NOT INTENDED FOR FIREPLACE INSERT.
Installation Instructions
Avoid installing the heater in front of the shortest wall of
a high pitched roof as the possibility of down draught will
cause problems with the heater operation and may not
be fixable.
Ensure there are no obstructions around the cowl
(i.e. overhanging tree branches).
Refer to the Australian Standard Gas Installations AS/NZS
5601.1: for ‘location of flue terminal’.
Terminating a flue in a roof space is not permitted.
To avoid any unnecessary delays and inconvenience
to your customer, please contact Technical Support on
1300 727 421 if the installation is unusual or you have
any concerns with the installation and/or heater operation
before the installation commences.
Make sure that the heater is fully commissioned and be
certain to test the integrity of the flue operation, taking
into account any influences created by range-hoods,
exhaust fans, central heating, etc.
Any service request resulting from incorrect
installations are not covered by our warranty
conditions and these calls will result in charges,
usually to the end user, so please ensure that the
installation and commissioning has been satisfactorily
carried out before calling for any warranty service.
Please make sure that your customer is fully instructed
on how to operate the heater.
FIG 4
100 mm minimum
side clearance
FIG 5
back clearance
Flue outlet
75 mm from
rear
1m min.
Clearances
Rear spacer
1. E
nsure the minimum clearances to combustible
construction are maintained during installation,
including adequate space for the proper operation
and servicing of the heater.
F
o r clearances to curtains and furnishings refer to
warning 4 & 5 on page 5.
For minimum clearances refer FIG 4 and FIG 5.
2. Remove the carton from the heater and lift heater from
wooden pallet.
C
h eck that the heater is suitable for the gas available.
Refer to the data label located on the left side panel
near the electronic control box.
( P lease dispose of packaging appropriately. Keep it
away from children).
3. P
repare electrical and gas connections, a 10 Amp
switch socket needs to be located within 1.5m of
the heater.
4. Fit rear spacers as per FIG 5.
Refer to Australian Standard Gas Installations AS/NZS
5601.1: for ‘commissioning’
40 mm minimum