Cannondale en 14764 Supplemental Owner's Manual - Switching On And Off
10
11
E-Series Owner’s Manual Supplement - 129184.PDF
Esp
añol
ITal
Ia
No
NEDER
la
ND
s
FR
aNÇ
aI
s
DEUT
sCH
ENG
lI
sH
Esp
añol
ITal
Ia
No
NEDER
la
ND
s
FR
aNÇ
aI
s
DEUT
sCH
ENG
lI
sH
switching on and off
switching the battery pack on is one of the possibilities
to start the eBike system. Read and observe the operating
in-structions of the drive unit and the drive HMI.
Before switching on the battery pack or the eBike system,
check that the lock 24 is locked.
note: When switching on the eBike system, the pedals of the
eBike may not be subject to load, as otherwise the output
ca-pacity of the drive will be limited.
To switch on the battery pack, press the on/off button 22.
The lEDs of indicator 21 light up and at the same time
indicate the charge condition.
note: When the battery-pack capacity is below 5%, none of
the lEDs of charge-control indicator 21 will light up. only the
drive HMI will indicate if the eBike system is switched on.
To switch off the battery pack, press the on/off button 22
again. The lEDs of indicator 21 go out. This also switches
off the eBike system.
When no power output of the eBike drive is requested for ap-
prox. 10 minutes (e.g., because the eBike is parked) and no
button of the drive HMI or operating unit is pressed, the eBike
system and thus the battery pack automatically switch off to
save energy.
The battery pack is protected against deep discharging, over-
charging, overheating and short-circuiting through the “Elec-
tronic Cell protection (ECp)”. In case of hazardous situations,
a protective circuit automatically switches off the battery pack.
When a defect of the battery pack is detected, two lEDs of
the charge-control indicator 21 flash. In this case, please
refer to an authorised bicycle dealer.
notes for optimum handling of the Battery
Pack
The battery-pack life can be prolonged when being properly
maintained and especially when being operated and stored
at the right temperatures.
With increasing age, however, the battery-pack capacity will
diminish, even when properly maintained.
a significantly reduced operating period after charging indi-
cates that the battery pack is worn out and must be replaced.
You can replace the battery pack yourself.
In case the carrying strap 28 of the standard battery pack should
be defective, please have it replaced by a bicycle dealer.
recharging the Battery Pack prior to and
during storage
When not using the battery pack for a longer period, charge
it to approx. 60% (3 to 4 lEDs lit on the charge-control
indicator 21).
Check the charge condition after 6 months. When only one
lED of the charge-control indicator 21 lights up, recharge
the battery pack again approx. 60%.
note: When the battery pack is stored discharged (empty)
for longer periods, it can become damaged despite the low
self-discharging and the battery-pack capacity may be
strongly reduced.
It is not recommended to have the battery pack connected
permanently to the charger.
storage Conditions
store the battery pack in a dry, well-ventilated location. pro-
tect the battery pack against moisture and water. Under unfa-
vourable weather conditions, it is recommended e.g. to remove
the battery pack from the eBike and store it in an enclosed
location until being used again.
The battery pack can be stored at temperatures between
–10°C and +60°C. For a long battery-pack life, however,
storing the battery pack at a room temperature of approx.
20°C is of advantage.
Take care that the maximal storage temperature is not ex-
ceeded. as an example, do not leave the battery pack in a
vehicle in summer and store it out of direct sunlight.