Cannondale en 14764 Supplemental Owner's Manual - Off
14
15
E-Series Owner’s Manual Supplement - 129184.PDF
Esp
añol
ITal
Ia
No
NEDER
la
ND
s
FR
aNÇ
aI
s
DEUT
sCH
ENG
lI
sH
Esp
añol
ITal
Ia
No
NEDER
la
ND
s
FR
aNÇ
aI
s
DEUT
sCH
ENG
lI
sH
switching the Push-assistance mode on/
off
The push-assistance feature makes it easier to push the eBike.
The speed in this function depends on the set gear and cannot
exceed 6 km/h (max.). The lower the set gear, the lower the
speed in the push-assistance function (at full output).
■ the push-assistance function may only be used when
pushing the eBike. Danger of injury when the wheels of
the eBike do not have ground contact while using the
push assistance function.
To activate the push-assistance function, press and hold the
“WalK” button 14 on the operating unit. The eBike’s drive is
activated.
The push-assistance function is switched off as soon as any
of the following incidents occur:
■ You release the “WalK” button 14,
■ You pedal in forward or quickly in backward direction,
■ The wheels of the eBike are blocked (e. g., through
braking or running against an obstruction),
■ Your speed exceeds 6 km/h.
switching the lighting on/off
Depending on country-specific regulations, two lighting versions
are possible:
■ The front light, rear light and display backlight can be
switched on and off at the same time via the drive HMI.
In this version, “lights on” is displayed for approx. 1 s
in text indication c when switching on, and “lights off”
when switching off.
■ only the display backlight can be switched on and off;
the front and rear light of the eBike are independent of
the drive HMI.
For both versions, the lighting is switched on and off by
pressing button 2.
speed and distance Indication
The speed indication e always displays the current speed.
The following functions are available in the function indica-
tion (combination of text indication c and value indication d):
■ “range”: Estimated range of the available battery-pack
charge (for constant conditions such as assistance level,
route profile, etc.)
■ “distance”: Distance covered since the last reset
■ “trip time”: Trip time since the last reset
■ “avg. speed”: average speed achieved since the last reset
■ “max. speed”: Maximum speed achieved since the last reset
■ “Clock”: Current time
To switch between the indication functions, press the “i” button
1 on the drive HMI or the “i” button 11 on the operating unit
until the desired function is displayed.
To reset “Distance”, “Trip time” and “avg. speed”, switch to
any of the three functions and then press and hold the “REsET”
button 6 until the indication is set to zero. This also resets the
values of the other two functions.
To reset the “Max. speed”, switch to this function and then
press and hold the “REsET” button 6 until the indication is
set to zero.
When the drive HMI is removed from the holder 4, all function
values remain stored and can be viewed.