Canon 2300N - ImageCLASS B/W Laser Reference Manual - page 57
Making Prints Using the Stack Bypass
2-14
Basic Oper
ations
2
1
Open the stack bypass.
● If the paper you want to specify is already loaded into the stack
bypass:
❑
Press [F2] (PAPER SELECT) to select the desired paper size.
● If the paper loaded in the stack bypass is not the paper that you
want to specify:
❑
Check to see if any job is reserved. (See "Checking the Job Status," on p. 4-2.)
If there is a reserved job, you can reserve a change of paper for the stack
bypass. (See Chapter 1, "Introduction to Copying," in the Copying Guide.)
If there is no reserved job, remove the paper already loaded on the stack
bypass and continue the procedure from step 2.
NOTE
If the paper size loaded in the stack bypass is different from the paper size stored
in the stack bypass settings, change the setting to the loaded paper size. (See
"Standard Paper for the Stack Bypass," on p. 3-16.)
2
Adjust the slide guides to the size of the paper.
Slide Guides
F2