Canon 2300N - ImageCLASS B/W Laser Setup - Load Paper.
LTR
U2 U3
B5
LGL
A5
A4 A4
A3
U1
B4
LT
R
ST
MT
B5
11
X1
7
LT
R
Unlock
Lock
3 Detach the blue end guide by
moving it down to the left then
pulling up, and attach it again at
the mark for the desired paper size.
4 Insert the paper size notice card in the
card slot located on the inside front of the
drawer.
7 Set the paper size detector lever to match
the size of the paper you are loading.
5 Attach the appropriate paper size label
to the paper size plate, and insert the
plate in the slot at the drawer front.
6 Lift up the blue lock lever and slide the
side guide to match the size of the paper
you are loading. Lower the lever again to
lock the side guide.
8
Load the paper into the drawer. Make sure
the paper size setting of the drawer
matches the size of the paper.
9
Even out the edges of the paper stack.
Make sure the height of the paper stack
does not exceed the limit mark
.
10
Push the paper drawer back into the machine. Repeat the steps above for the bottom drawer
as well.
Load paper.
1 Pull out the paper drawer until it stops.
1
2
2 Remove the black wire 1 and shipping tag,
and the orange tape 2.
NOTE
●
You can skip steps 3, 6 and 7 if you are loading letter size paper in the portrait orientation (LTR
).
●
Note that some paper sizes have both portrait (
) and landscape (
) settings.