Canon DADF-Q1 Service Manual - page 88
Chapter 3
3-10
3.3.5.3 Removing the Separation Motor Unit
0011-8133
1) Remove the screw [1], and detach the separation motor sensor support
plate [2].
F-3-65
2) Disconnect the two connectors [1].
F-3-66
3) Remove the three mounting screws [1], and detach the separation motor
unit [2].
F-3-67
3.3.5.4 Removing the Pickup Motor Unit
0011-8134
1) Disconnect J601 [1] and J602 [2], and free the cable from the edge saddle
[3].
F-3-68
2) Remove the two screws [1], and detach the belt motor driver PCB unit
[2].
F-3-69
4) Detach the fan mtor unit [1] by removing the two screws [2].
F-3-70
5) Disconnect the pick up motor unit [1] connecter [2] and open/ closed
sensor (rear) [3] connecter [4].
F-3-71
6) Remove the two mounting screws [1], and detach the pickup motor
unit [2].
F-3-72
3.3.5.5 Removing the Belt Motor Unit
0011-3448
3) Remove the three screws [1], and detach the belt motor unit [2].
[2]
[1]
[1]
[1]
[1]
[2]
[1]
[2]
[3]
[1]
[2]
[1]
[2]
[2]
[1]
[4]
[3]
[1]
[2]