Canon DADF-Q1 Service Manual - page 95
Chapter 3
3-17
to it. Take extra care when removing it not to damage the cables.
F-3-114
3.4.4.3 Removing the Separation Belt
0011-3610
1) Remove the two screws, and loosen the separation unit.
2) Remove the grip ring [1] at the front; then, remove the clutch ring [2]
and the clutch [3].
F-3-115
3) Disconnect the two connectors [1], and remove the two screws [2]; then,
detach the separation unit [3].
F-3-116
F-3-117
4) Remove the two mounting screws [1], and detach the separation auxiliary
plate [2].
F-3-118
5) Loosen the screw [3] on the separation pressure adjusting lever [2] of the
separation roller [3].
F-3-119
When mounting the separation pressure adjusting lever, be sure that the le-
ver is set to low.
F-3-120
6) Loosen the screw [3] on the thrust stopper [2] of the separation roller [1].
F-3-121
7) Remove the E-ring [2] and the gear [3] at the rear of the separation roller
[1].
The gear holds a pin. Take care not to lose it when removing the gear.
[1]
[1]
[1]
[1]
[3]
[2]
[3]
[2]
[1]
[3]
[2]
[1]
[2]
[3]
[1]
[1]
[2]
[3]
[1]
[2]
"High"
"Low"
[2]
[1]
[3]