Canon DADF-Q1 Service Manual - page 96
Chapter 3
3-18
F-3-122
8) Remove the E-ring [2] at the rear of the separation roller [1] to detach the
separation belt [3].
F-3-123
3.4.5 Delivery Roller
3.4.5.1 Disconnecting the DADF
0011-8141
1) Turn off the copier.
2) Disconnect the DADF's communication cable [1] from the copier.
F-3-124
3) Open the DADF fully.
4) Standing at the rear of the copier, lift the DADF to detach.
MEMO:
The hinge foot is equipped with a locking mechanism, requiring the DADF
to be fully opened for removal.
F-3-125
3.4.5.2 Removing the Front Cover
0011-8139
1) Remove the front cover [1].
-Three screws [2] (remove)
-One screw [3] (loosen)
F-3-126
F-3-127
F-3-128
3.4.5.3 Removing the Main Cover
0011-8140
1) Open the upper cover, and insert a screwdriver from above the hook; then,
remove the two hooks [1].
F-3-129
2) Free the hook of the pickup assembly cover [2] from the right stay; then,
detach it while paying attention to the hooks on the front and rear side
plates.
[1]
[2]
[3]
[2]
[3]
[1]
[1]
Lift.
[1]
[1]