Canon Digital ELPH User Manual - page 2
2
Transferring Images via a Wireless Connection
First, select a name for your camera and register it.
Register the name of the camera you wish to connect to your camera via a wireless connection.
z
You must follow the following procedures for both your own and the target camera.
Registering Your Camera Name
1
Slide the mode switch to
(Playback)
(Wireless) Menu [Set Camera Name]
z
Refer to the Camera User Guide for your camera for details on
Menu operation.
2
Set up name and press
.
z
You can set up the camera name with up to 5 letters. Select let-
ters using the
or
button, and press the
or
button to
move forward or backward. Capital letters and numbers can be
used for the camera name.
z
The default setting is [AAAAA].
z
If you do not wish to register a name, press the MENU button.
Registering Target Camera
1
Slide the mode switch to
(Playback)
(Wireless) Menu [Reg. Target Device]
2
Select [Camera] for target device and press
.
3
Make sure that your camera displays your camera’s
name and that the target camera displays its camera
name and press the
on both cameras simulta-
neously (within approximately 10 seconds).
z
This step connects your camera to the target camera and registers
each camera's name in the other camera as a target device.
z
When the wireless connection starts, the wireless lamp will begin to blink blue.
z
When you wish to change the name, follow Step 2 in Registering Your Camera Name (p. 2).