Canon ImageCLASS MF5730 Setup Instructions

Manual is about: imageCLASS MF5730 Series

Summary of ImageCLASS MF5730

  • Page 1

    Set-up instructions set-up instructions thank you for purchasing canon imageclass mf5730. To get your machine ready for use, please follow the instructions in this document before referring to any other documentation. Unpack the machine and its components. Check that you have the following: ● machin...

  • Page 2: Install The Cartridge.

    Assemble the cassette and load paper. Install the cartridge. 4 pull open the front cover. 1 remove the cartridge from the bag. Keep the bag in a safe place for future use. 2 gently rock the cartridge several times to evenly distribute the toner inside. 3 hold the cartridge on a flat stable surface w...

  • Page 3

    3 attach the extension to the cassette. The slots ➊ are keyed and must be inserted at a 90° angle. Once inserted, fold the extension as shown ➋ . 4 pinch and slide the rear paper end guide to match the size of paper. Note ● confirm that the paper guide is fitted in the paper size slit correctly. 5 l...

  • Page 4

    7 even out the edges of the paper stack. Make sure the height of the stack does not exceed the limit marks (a) and that the side edges of the stack are below the hooks (b). 9 insert the tabs on the extension cover into the slots ➊ on the back of the machine, and carefully lower the cover ➋ until it ...

  • Page 5: Connect The Power Cord.

    2 once it is warmed up, the standby display appears in the lcd. Connect the power cord. 1 plug the power cord into the rear socket ➊ . Then connect the other end to the wall outlet ➋ . Important ● for important safety instructions on installation and handling of the machine, see “important safety in...

  • Page 6: Install The Software.

    Install the software. Important ● do not connect the usb cable before installing the software. If you connect the usb cable before installing the software and the found new hardware wizard screen appears, click [cancel] and disconnect the usb cable. ● network connection is not available for this mod...

  • Page 7

    8 when the installation is complete, click [exit] to close the mf drivers-setup wizard screen. 9 on the mf setup screen, click [install mf toolbox]. 10 when the mf toolbox-setup wizard screen appears, click [next] and follow the instructions on the screen. Note ● before installing mf toolbox, make s...

  • Page 8

    Part no. Fa7-6515 (010) ©2005 canon inc. Canon and imageclass are trademarks of canon inc. All other products and brand names are registered trademarks or trademarks of their respective owners. Specifications subject to change without notice. Printed in china congratulations! You have now completed ...