Concept Pro VXM4-4 User Manual - page 23

20

CONFIGURING THE VXM4

CONFIGURING THE VXM4

SYSTEM: SYSTEM MANAGEMENT

F/W version: Shows the firmware version of the VXM4

H/W version: Shows the hardware version of the VXM4

VIDEO SIGNAL TYPE: The video input type is determined by the PAL/NTSC switch on the rear panel.

DISK CAPACITY: The first value shows the amount of hard drive capacity used by recorded footage,

the second value shows the total hard drive capacity installed.

IP ADDRESS: Shows either the manual IP address entered in NETWORK setup or the IP address

assigned by a DHCP server if enabled

MAC ADDRESS: Shows the MAC (Media Access Control) address of the VXM4. It is unique – no other

network device has this MAC address

SYSTEM NAME: A system name of up to 10 characters can be defined. It is used so that notification

emails can be identified.

F/W UPDATE: Firmware updates may be released periodically to enhance system performance and

add extra features. The operator can upgrade the firmware using a USB memory stick

FACTORY DEFAULT: If settings have been changed which cause erratic behaviour, the factory default

settings can be loaded

BACKUP USER DATA: System settings can be saved to a USB memory stick. The settings can be

reloaded in case of accidental factory reset or can be transferred to another VXM4 if multiple units

need to be installed with the same settings. All information is saved apart from network settings and

system name.

Although not yet supported, the VXM4 is currently being developed for use with a VA-KBDPRO

controller. This will allow up to 254 VXM4s to be controlled from the same keyboard

SYSTEM ID: If more than one VXM4 is connected on the same RS485 bus, each one must have a

unique ID

KEYCONTROLLER PROTOCOL: Must be set to VA-KBDPRO

KEYCONTROLLER BAUD RATE: Must be set to match the baud rate of the VA-KBDPRO PTZ

controller

SYSTEM: CONTROL DEVICE