Concept Pro VXM4-4 User Manual - page 27
24
CONFIGURING THE VXM4
CONFIGURING THE VXM4
RECORDING SETTINGS
To change RECORDING settings, highlight CONTINUOUS/MOTION RECORD SCHEDULE and press
ENTER
.
The 24 hour time bar is highlighted in purple.
Press
ENTER
to display the green cursor
The green cursor shown represents one hour (in this case between 00:00 and 01:00). The table above
the time bar shows the recording settings for this time period.
Example: To change the recording settings between 09:00 and 18:00
Use the
CURSOR KEYS
to move the green cursor to the 09:00 position and press
ENTER
. The
cursor changes to orange to show the start position.
Use the
CURSOR KEYS
to stretch the orange cursor across to the 18:00 position
Press
ENTER
. Recording settings for the selected time period are displayed.
SIZE: Recording resolutions of 352x288, 704x288 or 704x576 can be selected for each channel
FPS: Frame rates between 1 and 25 can be set for each channel
QUALITY: Four different picture recording qualities can be set for each channel
AUDIO: If audio devices are connected to the VXM4, any audio channel can be assigned to any of the
video channels
During playback, when a particular channel is selected in full screen, the assigned audio channel will
be played back at the same time
Adjust values as desired, and select OK to finish and return to the parameter menu. Other time periods
can be configured in the same manner.
Remember that if SCHEDULE
MODE is set to WEEKLY, recording
settings need to be changed for
each day as well as for each
particular time
The default settings for all
channels is 352 x 288, 25FPS,
HIGHEST quality
Note: The VXM4 supports a maximum recording rate across all channels of 100 frames per
second at 352x288 resolution. As settings are adjusted, the ‘frames available’ at bottom left
displays the number of available frames still remaining and must always be zero or higher.
If, whilst changing recording settings, this figure becomes negative, recording resolutions
and / or frame rates must be lowered to increase the ‘frames available’ value to zero or
above.