D-Link DAS-3324 Quick Start Manual - page 12
D-Link Confidential 10
subruleid 1 srcportfrom 137 srcportto 139
srcportcmp inrange
$modify filter rule entry ruleid
status enable
$create filter rule map ifname all ruleid
How to Enable Spanning Tree Protocol
Users can use the following command to enable spanning tree protocol. The commands are listed as below.
Command
Description
$modify stp info enable
Enable STP globally
$modify stp port info portid
Bridge port id: 1~193
$get stp port info portid
How to Enable IGMP Snooping
Users can use the following command to enable IGMP snooping. The commands are listed as below. Be
aware that IGMP Snooping is the Factory Default Setting.
Command
Description
$create filter rule entry ruleid
action sendtocontrol description IGMP
$create filter subrule ip ruleid
subruleid 1 prototypefrom 2 prototypecmp
eq
$modify filter rule entry ruleid
status enable
$create filter rule map ifname all ruleid
$modify igmpsnoop cfg info status enable
$modify igmpsnoop port info portid
fastNormal
or
$modify igmpsnoop port info portid
Fast
The feature is enabled in default.
How to Upgrade Control Plane Code Remotely
Users can use the following command to remotely upgrade control plane code. Make sure you have prepared
TFTP server,
vendor supplied CP.bin.gz , and put CP.bin.gz into root directory of TFTP server. The
commands are listed as below.
Command
Description