D-Link DAS-3324 Quick Start Manual - page 7
D-Link Confidential 5
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
–
–
C
C
o
o
m
m
m
m
o
o
n
n
U
U
s
s
e
e
C
C
o
o
m
m
m
m
a
a
n
n
d
d
s
s
f
f
o
o
r
r
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
Here provides some general and common commands used in IP DSLAM for users to
configure the IP DSLAM DSL Module.
Note: Please refer to the Command Line Interface manual for getting more commands
that IP DSLAM supports. Contact your dealer for advanced information.
How to Monitor DSL Status
Users can use the following command to check the status for specified DSL port. The commands are listed as
below.
Command
Description
$get adsl atuc physical ifname dsl-*
for downstream (*: 0 ~ 23)
$get adsl atur physical ifname dsl-*
for upstream (*: 0 ~ 23)
How to Enable/Disable a DSL Port
Users can use the following command to enable or disable DSL port for certain user. The commands are
listed as below.
Command
Description
$modify adsl line intf ifname dsl-* enable
Enable
(*: 0 ~ 23)
$modify adsl line intf ifname dsl-* disable
Disable
(*: 0 ~ 23)
How to Read DSL Training Rate
Users can use the following command to read DSL Training Rate for specified DSL port. The commands are
listed as below.
Command
Description
$get adsl atuc channel ifname dsli-*
for downstream/interleave channel (*: 0 ~ 23)
$get adsl atur channel ifname dslf-*
for upstream/fast channel
(*: 0 ~ 23)
$get adsl atuc channel ifname dsli-*
for downstream/interleave channel (*: 0 ~ 23)
$get adsl atur channel ifname dslf-*
for upstream/fast channel
(*: 0 ~ 23)