D-Link DAS-3324 Quick Start Manual - page 13
D-Link Confidential 11
$firmware upgrade CP.bin.gz CP
Upgrade the control plane code
How to Upgrade Full Image Remotely
Users can use the following command to remotely upgrade full image. Make sure you have prepared TFTP
server,
vendor supplied TEImage.bin.gz, and put TEImage.bin.gz into root directory of TFTP server. The
commands are listed as below.
Command
Description
$reboot config safe
Reboot from Safe mode
$create ethernet intf ifname eth-0 ip
$download src TEImage.bin.gz dest /nvram/TEImage.bin ip
(
or $download src TEImage.bin.gz dest /nvram/image/ ip
onwards)
Downloading the File.
...........................................................
Download file size is 1991180
Check if TEImage.bin shall uncompress
Uncompressing "TEImage.bin.gz" (11990111->4194304)......
TEImage.bin.gz is in proper format
Unlocking Flash........
Unlock successful
Erasing Flash ........................................
Erasing successful
Starting to Uncompress TEImage.bin.gz and Burn Flash
Uncompressing "TEImage.bin.gz" (1990111->4194304)......
#########################
Flash Programmed successfully
Done.
Download session Completed, Bytes received 1991180...
$
$reboot
Reboot from Default mode
Wizard Commands
In addition to the primitive commands described as above. Several wizard commands are provided which is
used easily. Type
wizard to see the command syntax.
Command
Description