D-Link DG-102SH User Manual - page 73
DG-102SH VoIP Station Gateway
67
If only nwdbg dns is typed, this command shows the DNS IP/STATE.
Parameter(s):
Example:
nwdbg dns 10.1.1.5
nwdbg dns
Definition:
This command turns on/off the DNS function.
If only nwdbg dns is typed, this command shows the DNS IP/STATE
Parameter(s):
[disable | enable]
Example:
nwdbg dns disable
nwdbg country
Definition:
This command provides country code setting interface to config the tone frequency for
different country.
If only nwdbg country is typed, this command shows the COUNTRY CODE
Parameter(s):
<0:USA, 1:Japan (Default)>
Example:
nwdbg country 1
nwdbg config
Definition:
This command shows all the configuration settings made by nwdbg commands.
Parameter(s):
None.
Example:
nwdbg config
ping
Definition:
This command lets the user ping an IP address from the device.
Parameter(s):
-n count: Number of echo requests to send. -w timeout: Timeout in seconds to wait for each reply. -i interval: The interval in half-seconds between two echo requests.> Example: ping 10.1.1.6 -n 100 -w 2 -i 1 ! When the user enters tftp, the screen will show all commands about the TFTP client: ggdbg>tftp tftp srvip tftp get – get the remote image file if image file name in EEPROM will be employed. tftp update – update the image in flash Current Settings : TFTP Server IP Address : 172.16.6.245 Image File Name : 102nmm01.tfp tftp srvip <IP ADDRESS> Definition: This command sets the IP address of the TFTP server. The image must be resident on that TFTP server. If the IP address is invalid, the message ERROR will be displayed. Example: ggdbg>tftp srvip 172.16.6.245 OK tftp get <FILENAME>