D-Link DGS-3224TGR - Switch User Manual - Access Profile Mask Setting

DGS-3224TGR Gigabit Ethernet Switch User’s Guide

73 

Figure 6- 56.  Bandwidth Control Table window 

To change the maximum allowed bandwidth for a given port in the Bandwidth Control Table window, click the selection 

button in the far left column that corresponds to the port you want to configure and click the Edit button. A new window 

opens: 

Figure 6- 57.  Bandwidth Control Table – Edit window 

To limit either the Rx or Tx rates, deselect the No Limit check box and enter the desired rate. Rates can be expressed using 

whole numbers up to the maximum available rate for the port. 

Access Profile Mask Setting 

Access profiles allow you to establish criteria to determine whether or not the switch will forward packets based on the 

information contained in each packet’s header. These criteria can be specified on a basis of VLAN, MAC address or IP 

address.