D-Link DIR-130 - Broadband VPN Router How To Set Up - page 6
D-Link Technical
Support – How to setup an IPSec VPN connection between a DIR-130 and DI-80xHV
Page
6 of 10
Step 3: Click on More under Method and configure as followed:
Tunnel Name: the name of the tunnel should already be entered if done in the previous step
•
Local Subnet: enter the local subnet (192.168.0.0 in this example)
•
Local Netmask: enter the local subnet mask(255.255.255.0 in this example)
•
Remote Subnet: enter the remote subnet (192.168.1.0 in this example)
•
Remote Netmask: enter the remote subnet mask(255.255.255.0 in this example)
•
Remote Gateway: enter the remote gateway (172.68.140.140 in this example)
•
IKE Keep Alive (Ping IP Address): enter an IP address of a client on the remote side
(192.168.1.100 in this example)
•
Preshare Key: enter preshare key as desired (Pre-share key must match remote side)
•
IPSec NAT Traversal: check to enable
•
Auto-reconnect: check to enable
Click
Apply to save the settings and click Continue when prompted.