D-Link DSL-302G Quick Installation Manual - Pre-Installation

Pre-Installation

This section explains how to physically connect the DSL-302G to your computer.

Before

you begin, visually inspect the rear of your computer and make sure it has either a USB

or Ethernet port as shown below. If you are uncertain as to the different type of ports,

please consult the manuals that came with your computer. If your computer does not

have one of the two ports, you need to purchase and install a USB or Ethernet adapter

before proceeding with the installation.

For USB:

• Your computer has a functional USB

   port.

• Only for Microsoft Windows

   98SE/Me/2K/XP Operating Systems.

For Ethernet:

• Your computer has pre-installed or built-in

   Ethernet adapter.

• Can be used for all Operating Systems.

 USB Port

         Ethernet Port

USB Installation 

(for Windows 98SE/Me/2K/XP)

    For USB Installation, please continue to step

    For Ethernet Installation, please continue to step

Insert the DSL-302G CD-ROM

into the computer. The following

auto-run screen will appear:

Click on Install Drivers &

Utility

Requirements:

Make sure that your ADSL service is enabled. If you are not sure, please contact your

ISP to verify. Since both ADSL and your telephone service uses the same telephone line

wire, you are susceptible to noise and interference. To eliminate these noise, you must

use a micro-filter with all other telephony devices such as your telephone, fax machine,

and answering machine. Please refer to the Appendix at the end of this guide for more

information.