D-Link DSL-302G Quick Installation Manual - Adsl Configuration

Now connect the telephone cable to the ADSL port on

the back of the device. Connect the other end of the

cable to the telephone wall jack.

To Power Supply

To Computer

To Phone Jack

Please proceed to step        to configure the DSL-302G.

ADSL Configuration

The Configuration Utility allows you to change the VPI/VCI settings of the DSL-302G to

connect to your ISP and also displays ADSL connection information.

 The DSL-302G

comes with a default VPI of “0” and a VCI of “35”. If your DSL service provider uses

different numbers, change these numbers on the modem to match those of your provider.

If you are unsure of the VPI/VCI numbers, check all documentation provided by your

DSL provider or contact them to get this necessary information. The DSL modem will not

work unless the VPI and VCI numbers exactly match those of your DSL provider. 

Follow

the steps below to change the VPI/VCI if necessary.

There should be a DSL-300 Family Configuration Utility icon on your desktop. (Alter-

nately, you can go to Start>Programs>D-Link DSL Family>DSL-300 Family Configura-

tion Utility) If it is not installed, please refer back to step 2 to install the Ethernet

Configuration Utility.

Double-Click on the icon.

When the utility is launched, it will

search for any DSL-302G on the

network and display them in the

table. If the modem does not

appear in a few seconds, click the

Discover button.

Note: If the ADSL Link LED does not glow green

within three minutes of it being connected,

check all your cable connections to make sure

they are correct and securely installed.

Click