D-Link DSL-302G Quick Installation Manual - Ethernet Installation
Other manuals for DSL-302G:
User Manual, User Manual
of
12
After the computer restarts, the USB drivers should now be installed.
Please proceed to step to configure the DSL-302G.
Ethernet Installation
(for all Operating Systems)
Connect the DSL-302G to a suitable power source.
Once the unit is powered on, insert one end of the
included Ethernet cable into the Ethernet port, and the
other end into the Ethernet port of the NIC card installed
on your computer. Make sure your computer is turned
on.
Note: If the cable connection is good, a green LED on the front of the device labeled
Ethernet/Link will glow steadily.
Click Finish to reboot
the computer