D-Link xStack DES-3526DC User Manual - Features
xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
2
This stand-alone Switch enables the network to use some of the most demanding multimedia and imaging applications
concurrently with other user applications without creating bottlenecks. The built-in console interface can be used to configure the
Switch's settings for priority queuing, VLANs, and port trunk groups, port monitoring, and port speed.
NOTE:
For the remainder of this manual, all hardware versions of the DES-3500 Series
switches will be referred to as simply the Switch or the DES-3500 except where the differences
are relevant.
Features
•
IEEE 802.3 10BASE-T compliant
•
IEEE 802.3u 100BASE-TX compliant
•
IEEE 802.1p Priority Queues
•
IEEE 802.3x flow control in full duplex mode
•
IEEE 802.3ad Link Aggregation Control Protocol
support.
•
IEEE 802.1x Port-based and MAC-based Access
Control
•
IEEE 802.1Q VLAN
•
IEEE 802.1D Spanning Tree, IEEE 802.1W
Rapid Spanning Tree and IEEE 802.1s Multiple
Spanning Tree support
•
Access Control List (ACL) support
•
Single IP Management support
•
Access Authentication Control utilizing
TACACS, XTACACS and TACACS+
•
Dual Image Firmware
•
Simple Network Time Protocol support
•
MAC Notification support
•
Asymmetric VLAN support
•
System and Port Utilization support
•
System Log Support
•
Support port-based enable and disable
•
Address table: Supports up to 8K MAC addresses
per device
•
Supports a packet buffer of up to 3 Mbits
•
Supports Port-based VLAN Groups
•
Port Trunking with flexible load distribution and
fail-over function
•
IGMP Snooping support
•
SNMP support
•
Secure Sockets Layer (SSL) and Secure Shell
(SSH) support
•
Port Mirroring support
•
MIB support for:
•
RFC1213 MIB II
•
RFC1493 Bridge
•
RFC1757 RMON
•
RFC1643 Ether-like MIB
•
RFC2233 Interface MIB
•
Private MIB
•
RFC2674 for 802.1p
•
IEEE 802.1x MIB
•
RS-232 DCE console port for Switch
management
•
Provides parallel LED display for port status such
as link/act, speed, etc.
•
High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881 packets/sec
on each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet port.
•
Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to simultaneously
transmit and receive data. It only works with connections to full-duplex-capable end stations and switches. Connections
to a hub must take place at half-duplex
•
Support broadcast storm filtering
•
Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
•
Supports by-port Egress/Ingress rate control.
•
Supports IP-MAC Port Binding.
•
Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
•
Supports STP Loopback Detection
•
Safeguard Engine Support