D-Link xStack DGS-3400 Series User Manual - Bandwidth Control
xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Bandwidth Control
The bandwidth control settings are used to place a ceiling on the transmitting and receiving data rates for any selected port. In the
QoS folder, click Bandwidth Control, to view the screen shown below.
Figure 7- 45. Bandwidth Settings and Port Bandwidth Table window
The following parameters can be set or are displayed:
Parameter Description
Unit
Select the switch in the switch stack to be modified.
From/To
A consecutive group of ports may be configured starting with the selected port.
Type
This drop-down menu allows a selection between RX (receive,) TX (transmit,) and Both. This
setting will determine whether the bandwidth ceiling is applied to receiving, transmitting, or both
receiving and transmitting packets.
No Limit
This drop-down menu allows the user to specify that the selected port will have no bandwidth limit.
Enabled disables the limit.
Rate
This field allows the input of the data rate that will be the limit for the selected port. The user may
choose a rate between 1 and 156249 units, where each unit is defined a 64Kbit/s.
Click Apply to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be displayed in
the Port Bandwidth Table.
151