D-Link xStack DGS-3426P User Manual - Lacp Port Settings
xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
LACP Port Settings
The LACP Port Settings window is used in conjunction with the Link Aggregation window to create port trunking groups on
the Switch. Using the following window, the user may set which ports will be active and passive in processing and sending LACP
control frames.
Figure 7- 18. LACP Port Settings window
The user may set the following parameters:
Parameter Description
Unit
Select the switch in the switch stack to be modified.
From/To
A consecutive group of ports may be configured starting with the selected port.
Mode
Active - Active LACP ports are capable of processing and sending LACP control frames. This
allows LACP compliant devices to negotiate the aggregated link so the group may be changed
dynamically as needs require. In order to utilize the ability to change an aggregated port group, that
is, to add or subtract ports from the group, at least one of the participating devices must designate
LACP ports as active. Both devices must support LACP.
Passive - LACP ports that are designated as passive cannot initially send LACP control frames. In
order to allow the linked port group to negotiate adjustments and make changes dynamically, one
end of the connection must have "active" LACP ports (see above).
After setting the previous parameters, click Apply to allow your changes to be implemented. The LACP Port Table shows which
ports are active and/or passive.
127