D-MAX DMS-200 User Manual - page 24
If user saves new positions without “DELETE”, all saved positions will be deleted automatically.
22. ALRAM CHANNEL ON/OFF
- CH On/Off : Alarm Input – Each channel can be
ON/OFF
- Alarm Relay : It can be set On or not when
ALARM OUTOUT PORT operate wrong.
- Active Alarm : It selects ACTIVE OPEN or
ACTIVE CLOSE by tangency when something is
wrong. It is ACTIVE when ALARM INPUT is OPEN
in ACTIVE OPEN, it is ACTIVE when ALARM
INPUT is CLOSE in ACTIVE CLOSE
- Resume Time Set :
It can select the delay time that the camera move
to the place alarming to observe where wrong
signal is sensed.
User can set it for 1sec to 180sec and operate GROUP, TOUR, SWING again in a preset time.
SWING, GROUP, TOUR are operated in a preset time when user stops the operating joystick in
the case of not connecting with the ALARM.
Press SWING, GROUP, TOUR keys without stopping of the joystick to stop the operating
completely (*Stopping the operating with the joystick affects the SET function.)
23. ALARM PRESET SET PAGE
■ The camera can move to a preset point
automatically when something is wrong in each
ALRAM CHANNEL.
■ Set a preset point firstly to move if anything
wrong, then use that sets the preset number into
each ALARM CHANNEL.
■ PRESET is out of connecting in ALARM
CHANNEL No.“0”
■ User can select PRESET number 1 to 250 and set it.
◄◄ CAMERA SETUP p3 ►►
18. Select Alarm : Sensor
19. Motion Detection : Off
20. Preset Set & Run Page
21.Trace Set Page
22. Alarm CH On/Off Page
23. Alarm Preset Set Page
24. Privacy Zone Set Page
- PREV MENU PAGE
- NEXT MENU PAGE
◄◄ CAMERA SETUP p3 ►►
18. Select Alarm : Sensor
19. Motion Detection : Off
20. Preset Set & Run Page
21.Trace Set Page
22. Alarm CH On/Off Page
23. Alarm Preset Set Page
24. Privacy Zone Set Page
- PREV MENU PAGE
- NEXT MENU PAGE