Dacor EDWH24S Installation Instructions Manual

Manual is about: Built-In Dishwasher

Summary of EDWH24S

  • Page 1

    Installation instructions 24-inch built-in dishwasher models: edwh24s and idwh24 part no. 106842 rev. C.

  • Page 2

    Ii installation instructions ...................................7 verify the package contents ...........................7 installation preparation ...................................8 installing the unit in the cabinet ...................10 water line connection .................................. 1...

  • Page 3

    1 important information about safety instructions • the important safety instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. • a...

  • Page 4

    2 important safety instructions • use this dishwasher only for its intended purpose as outlined in the use and care manual. It is not intended for commercial use. Read the use and care manual completely before use. • do not install or operate this dishwasher if it has been damaged, dropped, has dama...

  • Page 5

    3 3 1/4" (8.3 cm) 2 3/4" (7.0 cm) 54" (137.0 cm) long drain hose 44" (112.0 cm) long power cord back (152.0 cm) water supply line 60” long do not modify loop in hose product specifications drain hose c d handle depth 2” (50.0 cm) 5 1/4” (13.5 cm) to 7 1/4” (18.5 cm) depth with door closed depth dime...

  • Page 6

    4 grounding instructions for a permanently-connected appliance this unit must be grounded to operate properly. It must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding termi...

  • Page 7

    5 preparing the location warning follow all cabinet dimensions shown to insure safe operation. All minimum product dimensions must be met or exceeded (see page 3). Dimensions shown on the right provide the required clearances. • carefully check the location where the dishwasher is to be installed. P...

  • Page 8

    6 preparing the drain caution keep the factory installed high loop drain hose in place to ensure proper dishwasher operation. Do not modify or move the mounting bracket in any manner. If it is necessary to lengthen the hose, install an aftermarket drain extension kit, available at most home improvem...

  • Page 9

    7 planning the installation waste tee installation without air gap floor 20” min. Waste tee sink trap keep higher than tee connection disposer installation without air gap floor 20” min. Disposer connection sink trap keep higher than disposer connection waste tee installation with air gap 20” min. F...

  • Page 10

    8 installation instructions verify the package contents • remove all styrofoam and plastic wrap from the dishwasher. Be sure to remove the toe kick from the top of the dishwasher packaging. With the assistance of at least one person, remove the dishwasher from the shipping pallet. Place the unit to ...

  • Page 11

    9 installation instructions door panel installation (idwh24 only) important: • the front panel must be installed before proceeding with installation of the dishwasher. • for proper operation and to prevent cabinet or panel damage, do not allow the panel to obstruct the exhaust vent on the bottom of ...

  • Page 12

    10 handle installation ( model edwh24s ) install the door handle according to the handle installation instructions. Adjust the door springs before installation, open the door to check the door springs. If it tends to fall open or pull shut quickly on its own, adjust the springs. If the door opens an...

  • Page 13

    11 level the dishwasher caution a level unit is very important to proper operation. Be sure to level the unit front to back and side to side. The unit comes with white plastic feet for the legs to protect the kitchen floor from being damaged when you slide the unit into place. They snap onto the bot...

  • Page 14

    12 4. If a nonmetallic cable is being used, install a ul-listed strain relief bushing on the back of the dishwasher. 5. Connect the white wire on the cable to the “n” terminal on the dishwasher terminal block as shown below. 6. Connect the black wire on the cable to the “l” terminal on the terminal ...

  • Page 15

    13 installation instructions 5. Check again that the entire length of the power cable, water line and drain hose are free of pinches or kinks. 6. Verify that the dishwasher is level front to back and side to side inside the cutout. Re-level if necessary before testing the unit. Wet test checklist 1....

  • Page 16

    14 final leveling 1. Check to make sure that adjacent drawers and cupboards can be opened when the dishwasher door is open. Reposition the dishwasher if necessary. 2. Check that there is a 1/8” (3.0 mm) space between the top of the dishwasher door and the underside of the cabinet. 3. If necessary ad...

  • Page 17

    15 installation instructions 4. Hang the toe kick on the brackets as shown. Check to make sure that the toe kick is even with the kitchen cabinet toe kick. If necessary, remove the toe kick and readjust the brackets. Installation checklist warning • to ensure a safe and proper installation, the foll...

  • Page 18

    16 notes.

  • Page 20

    Dacor ● 600 anton blvd. Suite 1000 costa mesa, ca 92626 ● phone: (800) 793-0093 ● fax: (626) 403-3130 ● www.Dacor.Com item no., 80 895 92 rev. 03.