Dacor EDWH24S Installation Instructions Manual - page 11
9
Installation Instructions
Door Panel Installation (IDWH24 Only)
IMPORtANt:
• The front panel must be installed before
proceeding with installation of the dishwasher.
• For proper operation and to prevent cabinet or
panel damage, do not allow the panel to obstruct
the exhaust vent on the bottom of the door.
• For custom door panels, fabricate the panel
according to the included template and attach the
handle before proceeding with panel installation.
Custom Door Panel Installation:
1. Install the Dacor trim kit (PN 106925) on
the dishwasher according to the instructions
accompanying it.
2. Install the two (2) supplied 3/8” screws on the
back of the door panel in the locations shown,
leaving 1/8” (3.0 mm) of space between the
screw head and the panel.
Installation Preparation
WARNING
• Before working on wiring for any electrical appliance, be sure the electrical power has been turned off at
the breaker/fuse box. Place a tag at the disconnect switch indicating that you are working on the circuit.
• Moving this appliance requires two people. Do not attempt to install or lift it without assistance.
• To prevent personal injury, wear hand protection when moving this appliance.
• Do not allow any material, including the hoses or electrical wiring to be directly behind the dishwasher
while pushing it into the cutout opening. Carefully pull the slack out of both hoses and the wiring from
outside the cutout during push back to prevent pinching. An electric shock hazard or water damage may
result from pinched wires or hoses. Damage due to improper installation is not covered under warranty.
3. Hang the panel on the front of the door by
hooking the screws installed in step 2 over the
keyholes on the door.
4. Center the panel on the door.
5. Open the door slightly and use the six (6)
supplied 1 3/4” screws to secure the panel to the
door through the back.
Door Panel Screw Locations - 3/8” Screws
3/8” screw,
included,
2 places
15 7/16
"
39.2 cm
10 7/8"
26.6 cm
10 7/8"
26.6 cm
CL
Exhaust vent,
do not block
Hang door
on keyhole,
2 places
Attach custom panel with
1 3/4” screw through
back of door, 6 places