Dacor EDWH24S Installation Instructions Manual - page 16
14
Final Leveling
1. Check to make sure that adjacent drawers and
cupboards can be opened when the dishwasher
door is open. Reposition the dishwasher if
necessary.
2. Check that there is a 1/8” (3.0 mm) space
between the top of the dishwasher door and the
underside of the cabinet.
3. If necessary adjust the front leveling legs until
the dishwasher is the correct height. Use a
screwdriver to adjust the rear leg adjustment
screw. Both front legs must contact the floor
solidly.
4. Check to make sure the unit is level side to
side and front to back. Also check to make sure
both front legs are contacting the floor securely.
Readjust the leveling legs as necessary.
NOtE:
The unit may have an inclination of 3/16” (5.0
mm) maximum without affecting performance.
5. Once level, hand tighten the front leg retaining
nuts into place. Tighten them into place using a
crescent wrench.
1/8” (3.0 mm)
Installation Instructions
Attaching the Anti-tip
Brackets
CAUtION
Make sure to anchor one anti-tip bracket on each
side of the dishwasher.
1. The anti-tip brackets protect against possible
tipping caused by heavy bottom rack loads on
the door. Use only the stainless steel screws
provided with the machine.
2. Open the door and remove the top rack. Pull the
rack out. Turn both rack stops outwards on the
rack mounting rails (see diagram). Pull the rack
toward you to remove.
3. The anti-tip brackets may be secured either
through the top or the sides. Installations
with a hard material (like granite) may require
attachment through the sides.
4. When installing the screws, place the included
spacer over the screw. Insert the screws into the
holes in the anti-tip brackets through the access
holes in the top or sides of the door jamb as
shown below. Tighten the screws in place.
continued...
Access
hole
Spacer
Screw
Anti-tip
bracket
Attachment methods
or
Rack
stop