Dacor Epicure EGR30 Installation Instructions Manual - Nstallation
0
i
nsTallaTion
i
nsTRuCTions
V
eRifying
p
RopeR
o
peRaTion
WARNING
Before beginning the test procedure, ensure that all cooktop
control valves are in the “OFF” position, and all burner rings,
burner caps, and grates are properly positioned on the top frame.
Turn on the gas supply at the shut-off valve.
Turn on the power supply to the range. Set the time of day
by pressing the “CLOCK” key and then pressing either of the
“TIME•TEMP” keys to advance or reduce the time in the display in
the desired setting. Press the “BAKE” key. Select a temperature of
350˚F by pressing the “TIME•TEMP” “+” key. The display should
show “BAKE ON”. Press the “CANCEL•SECURE” key to stop
the oven heating process. Test each top burner separately by
pressing and turning one control knob at a time counterclockwise
to the “HIGH” position. All ignitors will spark continuously, but
only the burner with gas flowing to it will ignite. (It will take
approximately 4 seconds for ignition to occur, at which time the
ignitors will stop sparking. If ignition does not occur within 4
seconds, turn off the knob, wait for at least 2 minutes to allow any
gas to dissipate, then repeat this ignition test.) The control knob
can then be rotated counterclockwise from “HIGH” to “LOW” to
adjust the flame height progressively. Repeat the ignition test for
all burners. When installed properly, the flame will be steady and
quiet. It will also have a sharp, blue inner cone that will vary in
length proportional to the burner size.
1.
The range and shut-off valve must be
disconnected from the gas supply piping during
any pressure testing exceeding 1/2 psi (3.5kPa).
2.
The range must be isolated from the gas supply
piping by closing the shut-off valve during any
pressure testing at or below 1/2 psi (3.5 kPa).
NOTES:
If either the oven or cooktop does not operate
properly, follow these troubleshooting steps:
1.
Verify that power and gas are supplied to the
range.
2.
Check the electrical connections and gas supply
to ensure that the installation has been completed
correctly.
3.
Repeat the above bake test or burner ignition test.
4.
If the appliance still does not work, contact an
authorized DACOR
®
service company at
(800) 772-7778. Do not attempt to repair the
appliance yourself. DACOR
®
is not responsible for
service required to correct a faulty installation.