Dacor REMP16 Installation Instructions Manual - page 9
7
Electrical Installation
Run the wiring used to supply power from the installed
7.
raised vent or hood to the blower parallel to the duct
work.
Make sure that power to the raised vent or hood is
8.
disconnected or turned off at the circuit breaker or fuse
box.
With the UL certified strain relief attached to the end
9.
of the wiring/conduit, feed the wires into the electrical
access hole on the under side of the blower and attach
it.
From inside the blower assembly, strip the three wires.
10.
Connect the black (L1) wire to the L2 blower power ter-
11.
minal (see Figure 9). Tighten the terminal screw firmly
into place.
IMPORTANT: The L2 (hot) terminal on the
blower has the BLUE wire from the blower wiring har-
ness connected to it.
Installation Instructions
Connect the white (neutral) wire to the N2 blower
12.
power terminal (see Figure 9). Tighten the terminal
screw firmly into place.
IMPORTANT: The neutral (N2)
terminal on the blower has the BLACK wire from the
blower wiring harness connected to it.
Connect the green (GND) wire to the GND blower
13.
power terminal (see Figure 9). Tighten the terminal
screw firmly into place.
Check the wires from the blower wiring harness to
14.
make sure that they are firmly attached to the terminal
according to Figure 9. Reconnect any wires that are
loose. Make sure all terminal screws are tight.
Replace the blower’s top cover and screws.
15.
Secure the other end of the wiring/conduit to the hood
16.
or raised vent and connect the wires according to the
hood or raised vent installation instructions.
Verifying Proper Operation
WARNING
Read the raised vent or hood use and care manual
completely before operation.
Test the blower operation according to the Verify Proper
Operation section of the hood or raised vent installation
instructions.
If the blower does not work after having been properly
installed, contact Dacor Distinctive Service at (877) 337-
3226. Do not attempt to repair the unit yourself. Dacor is
not responsible for the costs required to correct problems
caused by a faulty installation.
Roof
Blower
Cutout
Wiring/conduit
connected to blower
Figure 8:
Wiring/Conduit Connection
L2 N2 GND
Not
Used
Wires from
hood/raised
vent
To blower
wiring harness
Black
Black
Blue
White
Green
Green
Figure 9: Wiring Diagram