Daewoo Video recorder Instruction Manual - page 19
19
Recording cassettes
◆
If you want to use the video’s timer to record a programme, the clock, date and stations must be set correctly.
◆
Load a cassette with its safety tab in place (see page 23) and with enough free tape for the recording.
Timer recording using VideoPlus+
VideoPlus is an automatic system which makes it easier to set the timer.
Press SV/V+ to select the VideoPlus screen.
(If this button is not
on your remote control, the function is not available on your
video. Go to page 20).
Videoplus numbers are shown in TV guides.
From your current TV guide, type in the number next to the
programme you want to record using the number buttons 0-9.
Press OK to confirm.
1
VideoPlus
0-9:VideoPlus number
:correct
OK:confirm MENU:end
VideoPlus Number
83077----
TIMER PROGRAM (Once)
PR
03
Start Time
21:20
End Time
22:20
Start Date
20/09(MON)
Tape Speed LP
PDC
ON
/ :correct
OK:confirm MENU:end
How often do you want
to record this program?
PR+/-:select
OK:confirm MENU:end
Once
Weekly(Once a Week)
Daily(Mon-Fri)
Daily(Mon-Sat)
Daily(Mon-Sun)
TMR
2
Press PR+ or PR- to select how often you want to make the
recording, for example, once, weekly and so on.
Press OK to confirm.
If you wish to changes any details:
Move to the details you want to change using the / buttons.
Change the setting using the PR+ or PR- or number buttons 0-9.
If all the settings are correct, press or until you see
‘OK:confirm’ on the button line of the screen. Press OK to
confirm.
3
4
Press to
switch your video off. Your video will not record
unless you do this.
You can switch the video on again if you want to set the timer to record
another programme. Remember to switch the video off when you have finished
setting the timer.
If PDC does not appear on the screen, it is not available on your video. PDC= Programme Delivery Control.
• PDC sets your video to adjust the start and end times of your timed recording. This happens even if a
programme starts earlier or later than advertised.
PDC works when the broadcaster sends a signal, but the signal is not always sent.
If you are not sure the signal will be sent, it is best to switch PDC off.
•
If there is no programme number displayed under ‘PR’ in the change menu, the video doesn’t yet know
the number for the programme you want. Type it in and this will be stored for later recordings.
•
If you wish to record from a satellite receiver, select under ‘PR’ the satellite programme or AV
(depending whether the video is connected with the antenna cable or the scart-cable). Leave the satellite
tuner switched on and set the programme you want to record.
•
The video will warn you if you have set the timer to start to recording a second programme before the first
recording has finished.
•
To stop the recording after it has already started, press and hold the STOP button for about five seconds
until the video stops recording.
•
VideoPlus + and Plus code are trademarks of Gemstar Development Corporation.
VideoPlus + system is manufactured under license from Gemstar Development Corporation.